RigPower Single Pole Power Connectors (HKMC-RIGPWR 10-17)

RIGPOWER CONNECTORS

C

E

T

N

O

N

R

O

S

C

VFD-1™ SERIES

H

C

A

Z

O

L

DESCRIPTION AND DESIGN FEATURES

VFD-1™ Female Receptacle

VFD-1™ Male Receptacle

FEATURES-SPECIFICATIONS

1 Alignment Screw – 90°/45° Stainless Steel Alignment Screw provides a secure attachment to the receptacle contact by way of a stainless steel Helicoil. 2 Bal Seal Canted Coil Springs ® – Bal Seal Canted Coil Springs ® are versatile electrical springs that offer improved contact performance and can provide longer service life in demanding environments. The small coil size and the number of independent coils make the springs suitable for a wide variety of electrical connector designs, with maximum contact points for optimal current-carrying capability in electrical and/or EMI shielding uses. 3 Dead Front Delrin ® Ring – The Female connectors come with the RigPower patented Dead Front Delrin ® Ring which provides increased safety by helping to prevent accidental contact. 4 Dead Front Tip – The dead front tip design is on both male and female contacts which increases personnel safety. 5 EMI Shield – Patent Pending flexible EMI shield at rear of panel mounted recepticle allows quick connection of cable shield braid to body of connector while maintaining

6 Flexible Rubber Insulation and the Flexible Electromagnetic Shield – The Flexible Rubber Insulation and the Flexible Electromagnetic Shield connect to the back end of the receptacle shell after installation. Once installed the ground contact band provides current carrying capability for EMI shielding. 7 Gland Nut – Large robust Gland Nut provides for an easy and safe connection to the receptacle. 8 Ground Contact System – Ground Contact System provides the required grounding connection to/from the receptacle housing 9 Hex Crimp – All electrical carrying components on the VFD-1™ series are made from Sn plated high conductivity copper. The receptacle lugs and plug contacts are designed to use the standard Hex crimp seen on all RigPower products. This standard crimp design provides a more robust and durable crimp and standardizes the tools needed. One set of four hex die sizes will accommodate all RigPower contacts from 4/0 to 777 MCM cables.

11 O-Ring Seal » » Each insulator has an O-Ring Seal designed into the body which offers improved mounting between the insulator and receptacle shell. » » Additionally, the O-Ring provides a water tight seal so that the component won’t have the propensity to short or burn out, even when the cap is not installed. 12 Rear Mounting Screws – Rear Mounting Screws provide for quick and reliable attachment of bonding wires 13 Rubber Boot – Patent Pending flexible rubber boot for using non-shielded cable inside enclosure. Flexes to accommodate 45 degree design lug. AMPACITY RATINGS IN 40º AMBIENT CABLE SIZE 90º C 125º C 4/0 MCM 364 AMPS 451 AMPS 313 MCM 513 AMPS 636 AMPS 373 MCM 548 AMPS 669 AMPS 444 MCM 642 AMPS 796 AMPS 535 MCM 724 AMPS 898 AMPS 646 MCM 814 AMPS 1009 AMPS 777 MCM 916 AMPS 1135 AMPS

10 Multilam Louver Strip – The Female connectors come with a Multilam Louver Strip which provides increased safety by helping to prevent accidental contact.

complete EMI protection. Flexes to accommodate 45 degree style lug.

Delrin® is a registered trademark of DuPont.

WWW.HUBBELL.COM/RIGPOWER/EN

CN33