BURNDY Master Catalog (20190422)

Exothermic Grounding

Making a BURNDYWeld ® Connection

Making a BURNDYWeld ® Connection

Step 1 Position cleaned conductors in mold after make sure mold is dry, by pre-heating or making a test joint.

Step 2 Place metal disc in bottom of mold crucible.

Step 3 Dump powder into crucible, being careful not to loosen all the starting powder.

Step 4 Close lid and place a small amount of starting powder in the ignition pocket.

Step 6 Wait 15 seconds, then remove weld and clean mold before making next connection.

Step 5 Ignite the starting powder with the Flint Ignitor.

1-800-387-6487 (Canada) 1-603-647-5299 (International)

E-97